Recycler Flying Wire Horizontal Can Disassembly

Document #:

Beams-doc-504-v1

Document type:

Figure/Photo

Submitted by:

Peter J. Wilson

Updated by:

Peter J. Wilson

Document Created:

13 Mar 2003, 12:15

Contents Revised:

13 Mar 2003, 12:15

Metadata Revised:

13 Mar 2003, 12:15

Abstract:

Photographs of the inside of the Horizontal can during
disassembly at E4R. These were taken after the system
was removed from the ring in March 2003. Photos show damage
to fork ends, ferrites and clearing electrode ceramic washers.

Files in Document:

• Debris in bottom of Horizontal FW can: a fork end, piece of ceramic washer and chips of ferrite (3/11/03) (dsc00081.jpg, 1.4 MB)
• End of for on horizontal can showing where tab broke off. (3/11/03) (dsc00094.jpg, 1.2 MB)
• Large ferrites in horizontal can showing chipping. (3/11/03) (dsc00083.jpg, 1.3 MB)
• PC board on fork end form Horizontal can. In this case the board complete but damaged.(3/11/03) (dsc00099.jpg, 1.3 MB)
• PC board on fork end form Horizontal can. Note that edge with copper trace and solder is missing. (3/11/03) (dsc00098.jpg, 1.3 MB)
• View in mirror of broken cermic washers on upper clearing electrode of horizontal can. (3/11/03) (dsc00089.jpg, 913.1 kB)
• View through beam flange of Horizontal can shows clearance of fork and broken ceramic washer on clearing electrode. (3/11/03) (dsc00101.jpg, 1.2 MB)

Topics:

• Upgrades:RR2003Winter
• Recycler:Flying Wires
• Recycler:Beam Instrumentation
• Instrumentation:Flying Wires

Authors:

• Alberto Marchionni