Minutes of meeting held on 11 Jul 2019
=========================

(i)  Curtis presented the 3D drawings of the BTL
     (1) The new injection point in Booster means that the "hook" will
     move ~6 m SE w.r.t. the baseline.
     (2) The distance between the last magnet outside the Bosoter to
     the first magnet inside Booster is about 10 m. This distance is
     determined by the required 5ft clearance from the existing wall
     of Booster for sheet piling.
     	(a) The "chute" will consist of an outer pipe that is between
     4" to 6" in diameter with an enclosed beam pipe of 2". The size
     of the outer pipe is subject to change.
     	(b) Denton says that the support for the beampipe will be on
     the ends of the chute. The support structure should not be a
     problem
	(c) Tan also asked whether the clearance for the last quads
     from the wall would be a problem. Denton did not think that this
     would be a problem.
     (3) Steve and Meiqin says that Bruce Hanna had a concern about
     the magnetization of the piling wall because of the close
     proximity to the quads.
     	       (a) Tan says that the pipe can be wrapped with muMetal
     if necessary. This concern will be looked at later.
     (4) The MI crossing point has 80" clearance. Compared to 76"
     required for the magnet mover. Therefore, there is enough
     clearance.
	(a) It is required that the BTL floor be ~4" higher than
     present survey. This is the solution that allows the clearance
     for the magnet mover.
     	 (b) Tan says that once the supports and the size of the
     magnet is finalized, the floor elevation will need to be tweaked
     as well.
     	(c) Curtis did a calculation to show that by elevating the BTL
     floor by ~4", the match to the existing Tev tunnel floor is
     within 0.1".
     (5) Curtis also showed the survey points that he'd like to be
     done during the shutdown.
     	  (a) Tan will send the info to O'Sheg.

(ii) Meiqin presented her lattice that matches the civil construction
presented by Curtis.
	  (1) The lattice looks good and has been designed to match
	  Dave's Booster lattice at the injection point.
	  (2) The dispersion is small and is not zero.
	      (a) Eduard would like to look at the lattice more
	      closely.

Summary
======
	The latest iteration of the lattice and civil construction is
	well coordinated. A solution for inserting PIPII linac into
	Booster has been found both in the lattice and civil
	construction. The civil construction is now a lot less
	destructive than the original proposal.